|
|
|
|
|
||||||||
|
|
|||||||||
| Home | Forums | Register | Gallery | FAQ | Calendar |
| Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
 |
|
|
Thread Tools |
April 13th, 2009, 22:48
|
#1 |
|
G36C Handgaurd pin retainment issues.
I have a KWA G36C and today the pin that hold the handgaurd (which also houses the battery) fell out during a skirmish. Upon close inspection it is "held in place" by a small o-ring. This o-ring tore, hence it's falling out. Not a great design in my mind. Any "fixes" that can be done besides replacing the o-ring that would be an improvement over the original design?
Thank you. |
|
|
|
|
April 13th, 2009, 23:27
|
#2 | |
|
Thread the end of it and stick a screw in it. That's what I did and it holds fine. You can krylon the screw or use a black plastic cap on it.
__________________
 Quote:
|
|
|
|
|
|
April 14th, 2009, 00:26
|
#3 |
|
Prancercise Guru
|
http://www.uncompany.com/pageproduct...sp?prodid=7594
Something like this is what you're after. The spring clip keeps it in place.
__________________
Airsoft, where nothing is hurt but feelings. |
|
|
|
 |
|
||||||
| Bookmarks |
|
|
 |
|
