trying to charge my battery

[oicurpn]

hey all,

does any one know if im doing something wrong?

I have a TLP EXPRO II Fuzzy Logic charger and it has a dial that you can adjust its amps 1.5 2 2.5 3 3.5 ect: I have been charging my battery at 2.5 and it seams to take 2h to charge or at least till the charger stops and beeps at me my battery is a 9.6V 4200 crane battery......after this charge i can only get out of the battery 6 mags 120X6= 720 rounds any ideas

[GraveTech]

2h at 2.5A for a 4200mAh battery sounds about right but (I think, someone correct me if I am wrong) the short lifespan of the battery is probably hinting at something wrong with your AEG. Is the battery hot when you remove it from your AEG? How about the botor or any other part of your AEG?

[Greylocks]

If you itemize exactly what is inside your mechbox (and if it was installed by someone with experience), we can take a shot at figuring out why your battery does not last.

Such a battery should be enough for a few full days of gaming, and/or a full bag of ammo.

[oicurpn]

now that you mention the motor it did seam to give off some heat and i did have some problems fitting the motor in to the new SPR grip every time i mounted the motor it started to grind, I finally got it in and cycling without the grinding noise i was pushing the motor to for into the grip. I'm guessing but i bet its the fit of the motor....it does not make any grinding noises at all maybe I will change the grip to the original and see what happens.

As for the meckbox it is stock except I did change the piston but i had fielded the new piston with the battery and old handle and it did not have a problem.

My gun VFC HK416 DX
meckbox stock internals except for the piston everything in-side is metal

[Styrak]

This has been a problem with someone else's 416 as well, I think.

[Greylocks]

If your motor is seated properly, and nothing was changed in the shimming, I have no idea what could be wrong.

I'd have someone look at it in person if possible.

[oicurpn]

my hk has a auto shim set it would adjust itsefl, and i did have the bat working properly with the old handle, i will change it back and give it a test

[Dawnbringer]

Originally Posted by oicurpn

my hk has a auto shim set it would adjust itsefl, and i did have the bat working properly with the old handle, i will change it back and give it a test

An auto shim set that adjusts itself, man I want one of those...

[oicurpn]

well I changed the SPR grip baco to the originol and it now works fine, my question would be how do i mount the motor in this grip from ehobby