JG G36 Trigger getting stuck on semi, Trigger stays back after shot.

[gerardcb]

Hi!

I have a JG G36C. When I put the gun on semi-auto, and pull the trigger, the trigger gets stuck on the pulled position.

I have to push the trigger forward in order to reset the trigger to push another shot out.

Thanks!

[Styrak]

Most likely your trigger return spring is broken/missing.

[Kid]

What happens in auto?

If it does work in auto, it's not the spring.

[gerardcb]

Yep it works well on full auto.

Just on semi it has the problem. And This gun is also missing the left side of the selector switch, but the right side still works well.

[Kos-Mos]

your trigger block (the electrical trigger part) if not aligned properly, the cut-off lever will hold it in place when engaged.

You have to open your gun (I assume again) and replace it properly. In V3 mechboxes it can be tricky.

[gerardcb]

ah ok thanks man im gonna try it.

Thanks guys!

[voorhees -FWA-]

it's probably your trigger return spring... like Styrak said, make sure it's there... attached to your trigger...