|
|
|
|
|
||||||||
|
|
|||||||||
| Home | Forums | Register | Gallery | FAQ | Calendar |
| Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
 |
|
|
Thread Tools |
December 21st, 2008, 13:51
|
#1 |
|
hi capa front sight problem !!
I just played some skirmish today with my hi capa (with metal slide installed) and the front sight fell off. When I tried to reinstall it, the fitment was so loose. Is there any trick to fix this or do I have to buy a replacement?>
|
|
|
|
|
December 21st, 2008, 14:08
|
#2 |
|
I used Loctite, realistically any sort of instant glue that works on metal should do....just make sure it's placed properly before you do it...
|
|
|
|
|
December 21st, 2008, 15:36
|
#3 |
|
What I've done, is place a paper towel or cardboard shim underneath while installing. Stays solid.
__________________
 Airsoft Sales and Repair/Upgrade Services |
|
|
|
|
December 21st, 2008, 17:27
|
#4 |
|
Tys
|
If the sight is so loose it just slides back and forth...I'd consider pinning the base...
You can very carefully nip the edge of the base with a punch and it'll create a bump that will wedge into place. But be careful...the base doesn't have a whole lot to it. Same with the slide...you can dimple the dovetail slot after the sight is in. I'd then put a tiny/half drop of crazy glue on it once it's in place...use a pin, put the crazy glue on the pin and place it where you want it. (otherwise it'll run). Best of luck, Tys |
|
|
|
|
December 22nd, 2008, 20:56
|
#5 |
|
thanks guys, I followed sir styrak method since it is the simplest one and it works just fine. Too afraid to try sir racing maniak's since I might change slide someday and I might want to re use the sight. Sir tyson: I think your method would need a lot of skill and I'm not fit to it
 . anyways, great replies, thanks and have a good day.
|
|
|
|
|
 |
|
||||||
| Bookmarks |
|
|
 |
|
