Airsoft Canada
https://www.replicaairguns.ca/airsoft

Go Back   Airsoft Canada > Discussion > Doctor's Corner
Home Forums Register Gallery FAQ Calendar
Retailers Community News/Info International Retailers IRC Today's Posts

MIAD Grip affecting the motor? Producing higher "rev" volume. Please help.

:

Doctor's Corner

Reply
 
Thread Tools
Old September 17th, 2008, 21:24   #16
Dynamo
Harvester of Noobs' Sorrow
 
Dynamo's Avatar
 
Join Date: Oct 2003
Location: T̆͒ͥ̓̿̅̈́̐͊̿͗̐̾̃͐ͧ&#8
Send a message via MSN to Dynamo
the problem is on the baseplate of the grip.
the treaded brass part doesnt fit over the endbell of the motor.
so the motor sits on top of the baseplate and cant be lowerd but only raised.
since it's already too high when sitting on the baseplate, adjusting the screw will only make it worse.
it would seem that MAGPUL forgot to check to see if the baseplate fits over the endbell. i had to modify my MIAD grip so the motor's endbell would fit in the screw hole. once that was done i could properly adjust the motor hight and now my gun is nice and quiet.

you will need to use a dremel and remove some material from that brass ring. at least 3mm deep and wide enough so the endbell of the motor can drop in without catching on anything.
__________________
Weapons Technician / Gunsmith



Don't look at me, I don't know, lol ¯\(°_o)/¯.
Dynamo is offline   Reply With Quote
ReplyTop


Go Back   Airsoft Canada > Discussion > Doctor's Corner

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Airsoft Canada
https://www.replicaairguns.ca/airsoft

All times are GMT -4. The time now is 08:55.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.