CA MP5A2 disassembly

[szetor]

anyone have experience? is the disassembly the same as a TM MP5? the one on mechbox.com?

i want to reroute the wire to the front of the gun.
anyways, the box of the gun claims "quick disassembly metal body"

if at all possible i don't want to take the motor or mechbox out kinda like this:

any one know what pins/screws to take out?

[dodger_me]

i think you need a front wire set(about 15 or 20 bucks) because all the wires are routed to the back and they need to be different lengths for the front

[Tankdude]

Two pins. One on the stock, one on the lower where the mag catch goes. Pull the stock off, disconnect wire.. Pull the lower straight back away from the upper and tada. Lower might stick a little.

Remove fore grip by the one pin just behind the front sight.
Or if you have a SD front end (big silencer) pull the square tabs out and slide the grip forward.

[Naglfar]

If it is like the TM, just detach the connector at the back of the mechbox, right where the stock connects, and connect a battery up to there, you can even leave the front wiring in and not use it.

[szetor]

Originally Posted by Tankdude

Two pins. One on the stock, one on the lower where the mag catch goes. Pull the stock off, disconnect wire.. Pull the lower straight back away from the upper and tada. Lower might stick a little.

Remove fore grip by the one pin just behind the front sight.
Or if you have a SD front end (big silencer) pull the square tabs out and slide the grip forward.

whhoa thanks man... really it was "tada" haha
is this design different from TM?

anyways this is why i'm rewiring:

pdw stock : )

too bad the ras can't fit a battery..

need to use this foregrip until i can find a battery solution

[Tankdude]

not really..but it's mostly the same.

Upper is a bit different on the TM and requires a little more work to get the lower out, but the basics are the same.