Hi-Cap Trouble

[JTF27]

Hey

I got a SIG 552 hi cap that stopped loading into my rifle. It winds up but it just doesn't seem to want to chamber the bb's. Anyone know what to do?

[CDN_Stalker]

Take it a apart and give it a good cleaning and lube. Check out the gears too carefully. I had an MP5 hicap jam on me, did exactly as you outlined, would wind fine but not shove BBs up the tube and put pressure on them. I did as I suggested above, and found a single grain of sand stuck between the teeth of the middle gear. I popped it out, lubed and reassembled, worked perfectly.

[JTF27]

I'll give it a try.

[Ronan]

Originally Posted by CDN_Stalker

Take it a apart and give it a good cleaning and lube. Check out the gears too carefully. I had an MP5 hicap jam on me, did exactly as you outlined, would wind fine but not shove BBs up the tube and put pressure on them. I did as I suggested above, and found a single grain of sand stuck between the teeth of the middle gear. I popped it out, lubed and reassembled, worked perfectly.

You and your sand grains... :P

[Renegade)]

Originally Posted by Ronan

You and your sand grains... :P

Happens when you, play, airsoft.

[arman]

yup what stalker said, had the same problem took it apart and just poked around and BAM it spun out.

[Spa]

I fixed my box mag before, it worked for a bit then the same thing happened again, now to load BB"s without the pressure i just let the motor run. I just cant figure it out ive taken it apart two times already.