|
|
|
|
|
||||||||
|
|
|||||||||
| Home | Forums | Register | Gallery | FAQ | Calendar |
| Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
 |
|
|
Thread Tools |
February 18th, 2007, 16:46
|
#1 |
|
Extendable Stock problems
So, I have an extendable stock installed on my M15A4. However, the bolt that clips it in place, is not doing its job. I spent most of last night trying to figure out how to make it fit so that it will catch, and its just not happening.....
Its the G&P Extended Battery Buttstock. Basically, to release the stock theres the clip on the bottom, which is also how it stays in place with a bolt basically. And theres the 4 pieces that are involved in it, The Release leaver, the spring, the nut and bolt. I cannot make it so when the bolt is in there attatched with everything, it will catch on the holes on the underside of the stock. Any help will be appreciated!
__________________
War does not determine who is right - only who is left. ~Bertrand Russell |
|
|
|
February 25th, 2007, 01:24
|
#2 |
|
So basically it just slides back and forth without catching? If that's the casem then I think the holes are smaller than the bolt. That was the case for me at one time.
__________________
"Any punk can shoot from across the room but it takes a real man to get close enough to stab" "Why cause a huge disturbance when you just wanna kill ONE guy?" - Chris Rock |
|
|
|
|
 |
|
||||||
| Bookmarks |
|
|
 |
|
