|
|
|
|
|
||||||||
|
|
|||||||||
| Home | Forums | Register | Gallery | FAQ | Calendar |
| Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
 |
|
|
Thread Tools |
February 12th, 2014, 00:16
|
#1 |
|
ICS L85 receiver problem
I have a problem with my new ICS L85. The upper and lower receivers don't seem to fit together quite right. There is a gap and the bottom wobbles. The body pins are in correct. Anybody else encounter this problem?
Here is a picture. |
|
|
|
|
February 12th, 2014, 12:44
|
#2 |
|
Looks like your lower is not in correctly. Its a bit tricky, but you have to angle your lower when installing to hook in to the frame. Open it back up and inspect where it connects. You will see where it hooks in.
__________________
A.K.A. BUDHA ________________ Today's post is brought to you by the letter F Level 2 sniper certified / night operator |
|
|
|
|
February 12th, 2014, 12:47
|
#3 |
|
Yeah I found that sometimes the trigger contacts can not be aligned and cause problems with the receiver spacing, just try taking it apart and reseating it.
__________________
Proud owner of:
-TM Scar H Vfc 416 -Ares G36c TM Glock 18c -G&G F2000 KWA Vector -VFC FNX45 G&G P90 -G&G M14 EBR G&G AKS-74 -KWA USP Tac TM 1911a1 -TM 5-7 WE MP5k -VFC Mp7 VFC HK417 -Scorpion Evo SMG Scorpion Evo Carbine |
|
|
|
|
April 2nd, 2014, 15:48
|
#4 |
|
I was able to fix the problem by using some very small pieces of hockey tape. I used about 6 layers of tape, placed at the bottom of the hook, where the lower receiver latches onto. The tape causes the bottom receiver to be pushed up into the top receiver. Be careful not to put tape at the front of the hook, this would cause the receiver to be pushed backwards.
|
|
|
|
|
 |
|
||||||
| Bookmarks |
|
|
 |
|
