|
|
|
|
|
||||||||
|
|
|||||||||
| Home | Forums | Register | Gallery | FAQ | Calendar |
| Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
 |
|
|
Thread Tools |
June 25th, 2012, 12:55
|
#1 |
|
XM108HP doesnt hold gas - Need advice
I have a strange issue now. I reassemble it correctly (as mentioned in the other thread), but it doesn't hold gas. When I fill it, all the gas comes out through the BB holes and when I open it up again, two of the bearings have fallen out of the valve into the lower half where the spring/plunger sit.
Any ideas?
__________________
H&K G36c (KWA) / Glock 18c (TM) / Kimber LAPD SWAT Custom (TM) / Mossberg M500 (ACM) 
|
|
|
|
June 25th, 2012, 13:42
|
#2 |
   Join Date: Feb 2005
Location: Swimming in a pool of Xpresspost receipts.... Toronto - 400/401
|
It is normal for bearings to fall out during disassembly.
It's probably not primed. After assembly, push the release valve all the way up with a screwdriver.. you should feel the bearings reset Other possibilities are one or more warped bearing holes in the main gas valve, or damaged o-rings. Inspect them all before re-assembly.
__________________
|
|
|
|
|
July 20th, 2012, 01:24
|
#3 |
|
I think it is the big o-ring problem.
|
|
|
|
|
 |
|
||||||
| Bookmarks |
|
|
 |
|
