G&g pm5 a5

[BlackAven]

Hey guys, about a year and a half ago I bought a G&G PM5 A5. Less than 6 months later it broke. Today I have fully opened it up because I knew the problem was in the gear box. There is a chip of plastic that has broken off of the piston. I am wondering if it would be possible to buy a new piston, or if I should get a new gear box or if I should get a new gun entirely.

[Dooms]

Yes, You can buy a new piston! Gearboxes and full internals are expensive. Throw in a $30 piston and you are good to go.

[Styrak]

Actually he only needs the piston head. But you could also buy a piston+head set.

[BlackAven]

Thanks. Would this one work? http://www.airsoftgi.com/product_inf...oducts_id=4274 and if not what one would I get and where would I get it from? As far as I know this one is for g&g's but I cant tell witch one or if it will work in all g&g's.

[Styrak]

No don't buy that, it's the same shittily-designed G&G piston head, which are the worst in the industry. They should be ashamed to even sell it as an aftermarket product as it's a downgrade from anything else.

Why don't you buy in-country? www.airsoftparts.ca

[BlackAven]

Very helpful thanks!

[Styrak]

If you didn't know, with the exception of maybe a few weird guns, all mechboxes take the same piston and piston head.