|
|||||||||
|
Home | Forums | Register | Gallery | FAQ | Calendar |
Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
|
Thread Tools |
December 18th, 2010, 14:40 | #1 |
KJW M9 question
Hey I have a KJW M9 and I want to replace the outer barrel assembly with this
http://shop.ehobbyasia.com/madbull-2...-and-m9a1.html would it by compatible with a WE one like this? I'm pretty new to GBBs, I know that they are good with TM parts... from what I can see they are very similar but I am not sure
__________________
Kingston airsoft, we do it better. |
|
December 18th, 2010, 14:46 | #2 |
No, WE's are their own design.
|
|
December 18th, 2010, 14:49 | #3 |
DAMN
k, what I need is something like that for my kjw... where could I find one?
__________________
Kingston airsoft, we do it better. |
|
December 18th, 2010, 14:58 | #4 |
Red Wine & Adderall
|
You can find a threaded outer barrel for KJs. Im not sure if anyone makes any type of TB for them.
__________________
"Its only a little bit on fire" |
December 18th, 2010, 15:05 | #5 |
there is just a problem with my kjw.... the bbs just roll out the end and I figure I could get the problem fixed by a doc or I could just buy a new unit, they are not that expensive so I dont mind... Its just hard finding them
I have seen a threaded outer barrel made by KJW but I would like the hopup as well EDIT: I want to replace it because its about 3 years old
__________________
Kingston airsoft, we do it better. |
|
December 18th, 2010, 17:19 | #6 |
The issue with your gun is the hopup. The grub screw stripped the thin metal that presses down on the hopup rubber. To the best of my knowledge, you can't get after-market parts.
However, you should be able to replace the whole chamber / outer barrel / hopup assemly with a TM one. They're different than the KJW design, but I've been told if you replace the whole thing, they do work. I can't 100% guarantee that since I've never tried it myself, but it's what I've been told. So assuming what I've said is correct, you need what's in your original post, but designed for TM instead of WE. I don't know how close WE is to the TM or KJ design, so I can't really comment on it. I've never even seen a WE M9 in person.
__________________
|
|
December 18th, 2010, 18:02 | #7 |
replacing the whole thing really shouldnt be too expensive considering that the WE one is about 50 bucks (not shipped). I will keep looking around, I'm sure one will show up eventually
__________________
Kingston airsoft, we do it better. |
|
|
Bookmarks |
|
|