VSR-10 NonCommon Bolt Problem

[gerardcb]

Hi! Ive been having this problem for almost a year now.

My tm vsr-10 has been having rough bolt pulls and pushes. It also created problems too.

Ok i used to use the zero trigger. With the zero trigger and the neo piston it came with, the bolt pull was very rusty and rough. So I thought it was the zt.

So i bought neo piston for regular trigger mech, but upgraded the trigger mech.

STILL ROUGH AND RUSTY!

Now, i tried using it today and I put the gun on safety. Then i pulled the trigger slightly. When I released the safety, IT FIRED!

So now, it has rough bolt pull and push and on top of that there have been having some problems.

Please if u know how to solve this problem...

Thanks =)

[lemegacool]

is the receiver free of any burr or obstacles that can interfere with the bolt pull? for your safety problem, maybe the trigger screws needs some adjustments...

[gerardcb]

Originally Posted by lemegacool

is the receiver free of any burr or obstacles that can interfere with the bolt pull? for your safety problem, maybe the trigger screws needs some adjustments...

sure its free of crap. I tried putting the stock piston in and its as smooth as butter. Stick the noe back on its rough again.

For the trigger maybe that could b. Can u b anymore specific? Wat exactly should i adjust and how much? Thanks!