Replacing selector switch

[Gunny_McSmith]

but if you cant wait to fix it, you could aways do it yourself...

1) the motor plate from the grip
2) remove motor
3) remove grip

4) remove mag catch
5) remove the gearbox pin (its located over the trigger)
6) remove the stock & buffer tube

7) remove the lower receiver

8) take the lower receiver, (put the selector on SEMI before poping the lower off)

9) pop the fake selector lever plate on the right side like (see pic below) (its often superglued in, so be careful, since you have a plastic lower)



10) and finally, insert a screw driver in the hole, to tighten the selector switch screw

11) check if you like it, then reverse the steps to put your gun back :P

PS: dont forget the small tapet plate spring, or you're gun wont fires in Semi auto :P

PPS: here's a guide on how to take appart you're m4/m16 variant

hope it helps

[Boyso]

You don't remove the cut off lever spring when you take it out the receiver actually ^^

But yeah, it's easy. If it doesn't click, it's because, either it's too slack, or you lost the small spring underneath the selector switch.

[Gunny_McSmith]

Originally Posted by LastSpartan

You don't remove the cut off lever spring when you take it out the receiver actually ^^

But yeah, it's easy. If it doesn't click, it's because, either it's too slack, or you lost the small spring underneath the selector switch.

it could always pop off... :P

[Boyso]

Yeah, just to add, put the selector on semi before popping out the GB, much easier.

[Gunny_McSmith]

Originally Posted by LastSpartan

Yeah, just to add, put the selector on semi before popping out the GB, much easier.

thx... edited my post.. :P

[Brokenwings]

Shit that is epic confusing for a total noob (me) O.O

...

O.O http://www.mechbox.com/m4m16/m733-disassembly.html

From there on, what do i have to do? (at the end of the vid)

Help form there would be pretty much better for me. lmao sorry, and thanks? :P

[Boyso]

Have you removed the gearbox from the receiver? Don't open the gearbox, if you don't intend to upgrade it.

If you have removed the gearbox from the receiver, simply tighten the screw.

Take pictures if you can, could help us guide you thru it.

[Brokenwings]

Sounds good, pics will be up by tmmrw, watching season finale of Lost lmao