m16 firing problem

[alexh123animals]

i recently reassembled my jg m16a4 when i try to fire it it fires but no bb comes out the barrel then the bb slides out the barrel. sometimes i shoot it a couple of times and the bb's seem to get stuck in the barrel the barrel is not dirty or anything inside what could be the problem

[Styrak]

Tappet plate spring perhaps?
Did you take the mechbox apart?

[Big Pepa]

Originally Posted by alexh123animals

i recently reassembled my jg m16a4 when i try to fire it it fires but no bb comes out the barrel then the bb slides out the barrel. sometimes i shoot it a couple of times and the bb's seem to get stuck in the barrel the barrel is not dirty or anything inside what could be the problem

That once happened to me. I forgot to put the air nozzle in when reassembling the gearbox.

Rip it down and put it together again. Probably nothing serious.

[Azn_Badger]

ya i would also think that theres a problem with the tappetplate or the nozzle. Or, it just might be that you got ur hopup turned off or too tight

[BORDENSNIPER]

Before u take ur gun apart,

#1 ensure ur hopup rubber interior is fine, and not mashed up or ripped.
#2 crack the rifle open, and with ur fingers move the nozzle into the gearbox (push it in), if it resists and then pushes back then it is not a gearbox internal problem, might be a mag issue.
#3 if u find that ur nozzle is loose take the gerbox apart and put the nozzle back into the tappet plate slot however, this might be a broken tappet plate so eplace accordingly to wat the problem is.
#4 if it is the nozzle that is loose/not on tappet plate, check the double circle grooves of the nozzle (the ones the appet plate slot goes into), Ive encountered many JG V2's were the grooves on the nozzle crack on the sides.If they are cracked, then buy a madbull o-ring nozzle.

cheers,

tell us how this went