|
|
|
|
|
||||||||
|
|
|||||||||
| Home | Forums | Register | Gallery | FAQ | Calendar |
| Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
 |
|
|
Thread Tools |
February 1st, 2009, 20:09
|
#1 |
|
TM P226 Magazine issues...
Ok I'm having issues with my P226's magazine.
I was firing off today and after a few quick consecutive shots the valve in the magazine got stuck, and spewed all the gas out converting my poor P226 into full auto for a quick second or two. I took the valve out relubed it, then put it back in. And I noticed that the valve was sticking out a bit more than it was suppose too... I dont know if this is suppose to be the length of it or if it's damaged or not. But now after firing off about 15 shots the valve gets stuck again, and causes me to take the whole magazine apart. please help =[ It could be one of the O-Rings inside are blown, cause I notice everytime I take the mag apart one of O-rings gets kinda stuck inside.
__________________
"Don't you know the first law of physics? Anything fun costs atleast $8" 
Last edited by sushicake; February 15th, 2009 at 23:06.. |
|
|
|
February 1st, 2009, 20:16
|
#2 |
|
looks pretty close to what mine look like and the work fine. If anything it might be sticking out a tiny bit more on yours. cant say for sure if it looks damaged tho.
|
|
|
|
|
|
February 1st, 2009, 20:18
|
#3 |
|
|
Actually nevermind I figured it out, one of the O-rings inside shifts and jams the valve thus causing it to get stuck...
__________________
"Don't you know the first law of physics? Anything fun costs atleast $8"
|
|
|
|
|
February 1st, 2009, 22:05
|
#4 |
|
|
Ok it started to get stuck again...
Now the valve jams, I replaced the O ring and that's not shifting anymore. Just the valve jams now anyone know how to take it apart?
__________________
"Don't you know the first law of physics? Anything fun costs atleast $8"
|
|
|
|
 |
|
||||||
| Bookmarks |
| Thread Tools | |
|
|
 |
|
