|
|||||||||
|
Home | Forums | Register | Gallery | FAQ | Calendar |
Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
|
Thread Tools |
December 13th, 2006, 14:15 | #1 |
ICS MP5 A4 dead, need help and diagnostic
Recently I turn the screw for the motor adjustment to try to enhance the sound of the gun, it was strange (one full turn). I shoot with the gun for half a mag and suddently it stop firing and the trigger was jam. I retreive the mag and I saw a BB in the feedind tunnel. I shoot without the mag and the BB fly away. I try again with the mag and the same problem occur. Since now the gun refuse to shoot, no motor noise, dead meat...
The barrel is not obstruct, the Hop-Up is on the lower position, my battery is full, the fuse is ok, but nothing happend. Anyone have a suggestion ? What step do you suggest me ? What should I try now. Thank |
|
December 13th, 2006, 14:22 | #2 |
well, you may have adjusted the motor too much and it is locked up inside the mechbox, I woudl try pulling the motor out and re adjusting it. Check for stripped/ damaged teeth on the motor gear itself...
Another issue that I recently dealt with was that we turned the motor adjustment screw too high and disconnected the power to the motor... Both require minor assembly...
__________________
Proud owner of a pile of airsoft guns and kit with the credit card bills to prove it! Last edited by Mud Gunner; December 13th, 2006 at 15:37.. |
|
December 13th, 2006, 14:22 | #3 |
which way did you turn the screw? in or out? 1 full turns seems like a lot, but im no expert
|
|
December 13th, 2006, 18:17 | #4 |
December 13th, 2006, 18:20 | #5 | |
Quote:
Thank |
||
December 13th, 2006, 18:23 | #6 |
There are two wires that connect to the motor, they are simply pushed back onto the metal connectors on the motor itself. This is done by removing the motor plate in the pistol grip.
__________________
Proud owner of a pile of airsoft guns and kit with the credit card bills to prove it! |
|
December 13th, 2006, 18:29 | #7 |
http://www.mechbox.com/site/mp5-disassembly-video.html
reference this video from 2:08-2:35 turn the adjustment screw the oposite way then you did before to loosen it a bit and see if it starts going. Mostly sounds like a bad connection or a disconected motor. The motor would still sound like it's working even if it jammed. Check you fuse agian.
__________________
age verifier for Prince George, Mackenzie, Quesnel, Fort st James and northren BC http://pgairsoft.goodforum.net/index.forum Last edited by Hortons Heros; December 13th, 2006 at 18:30.. Reason: I |
|
December 13th, 2006, 20:03 | #8 |
December 13th, 2006, 20:06 | #9 | |
Quote:
I keep you inform. Thank you, I appreciate. |
||
December 15th, 2006, 00:48 | #10 |
December 15th, 2006, 02:51 | #11 |
HORAY!!
__________________
age verifier for Prince George, Mackenzie, Quesnel, Fort st James and northren BC http://pgairsoft.goodforum.net/index.forum |
|
|
Bookmarks |
Thread Tools | |
|
|