|
|
|
|
|
||||||||
|
|
|||||||||
| Home | Forums | Register | Gallery | FAQ | Calendar |
| Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
 |
|
|
Thread Tools |
July 1st, 2011, 02:31
|
#1 |
|
PSS10 Zero Trigger Part# or Viable Substitute
Hello everyone.
Dont ask me how but I broke the Main sear return spring inside my PSS10 zero trigger. Its the spring the Brings the sear back to position after releasing the trigger. Does anyone know the part number or a Viable replament spring. Being this one is Broken, I do not know the orentaion of the ends Nor the proper length so any help would be greatly apprciated SV On a happy Note I ranged My tm1911 today (installed a 112mm Madbul inner) Propane & devil 25s Stock Hopup at 75% +/- 5% 25 feet 4 inchs above bullseye, 50 2" above bullseye, 75 1" above Bullseye. doing 100" feet tomorrow 
__________________
A single Light is all one needs to find their way through the darkness, But a single BB is all you need to bring it on! ========== Im not worried about the Bullet that has my Name on it, Im worried about the bullet that says "to whom it may concern" Lt. Alexander Washington -(Red Tails 1944) Ret. |
|
|
|
July 1st, 2011, 23:39
|
#2 |
|
|
Yaawhooo
So enter the trigger return spring from a modify V2/3 Spring set. THE VSR LIVES
__________________
A single Light is all one needs to find their way through the darkness, But a single BB is all you need to bring it on! ========== Im not worried about the Bullet that has my Name on it, Im worried about the bullet that says "to whom it may concern" Lt. Alexander Washington -(Red Tails 1944) Ret. |
|
|
|
 |
|
||||||
| Bookmarks |
| Thread Tools | |
|
|
 |
|
