Need an allen key size please!!!

[MasterChiefLP]

I have a KSC Glock 18C and i need to remove the allen screw from underneath the rear sights, im not sure what size the screw is so im asking for some assistance. Can someone please tell me then screw size so i can purchase the correct bit, One more favour...if you can find the allen screwdriver for me on ebay and link it on here that would be amazing.

[Forever_kaos]

https://www.1977mopeds.com/PDGImages...en-Key-457.jpg
I have 2 things sort of like this.
1 is Imperial and the other is Metric.

Best advice I can give you. Best of luck.

[Styrak]

If you have a Source by Circuit City (old RadioShack), you can go in there and get a 30-40 piece bit set which includes TINY hex and torx bits for like $10.

The brand is NexxTech or something like that, in a yellow case.

It's the only one I found that has bits that small.

[MasterChiefLP]

Alright but can you see if there are any on ebay? As again i dont know the exact size and i dont want to purchase something if it wont fit it. Thanks for your help though

[Qlong]

0.9 milli-metre

[Styrak]

Actually I think it's 0.7mm

[Qlong]

I know for a fact it is 0.9mm.

[MasterChiefLP]

Yeah now if i can only find that to purchase online...

[Qlong]

You can buy a metric kit at Walmart ...then return it when you're done if you like.

[MasterChiefLP]

http://www.filmtools.com/wihmicdriv03.html

I found this, its much easier for my situation

[MikeMcNair]

i had a post of these for sale for a while. if you PM me your address, i will send you one for free.

[coach]

Originally Posted by Qlong

You can buy a metric kit at Walmart ...then return it when you're done if you like.

for even suggesting it, you are a tard and should be banned from ever returning anything for a refund!

[MikeMcNair]

i will send this cat a free one, all you other haters relax

as agreed, PM me on tues.