|
|||||||||
|
Home | Forums | Register | Gallery | FAQ | Calendar |
Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
|
Thread Tools |
April 30th, 2009, 00:57 | #1 | |
6mm or 7mm in G&G Cansofts??
I would like a gun doc if possible to confirm this..
The G&G GR16 cansoft versions from Mach1 and CAS, etc etc.. Are the bushings 6mm or 7mm. I really need a solid answer as I'm in need of ordering some internal parts. I'm thinking 7mm as they seem bigger than those in my other gun which are 6mm.
__________________
Quote:
Age Verification for Southern and Northern Manitoba.(Steinbach and surrounding area, Thompson and surrounding area. As far north as Churchill) Contact Me Here
|
||
April 30th, 2009, 01:04 | #2 |
They are 7mm bearing bushings.
|
|
April 30th, 2009, 01:10 | #3 | |
lol..
You had said that before. Ok I just need to be sure as I'm ordering FTKs through Jugglez and I think those kits are with 6mm bearings, so I'll need to get 7mm v2 gearset instead. Thanks
__________________
Quote:
Age Verification for Southern and Northern Manitoba.(Steinbach and surrounding area, Thompson and surrounding area. As far north as Churchill) Contact Me Here
|
||
April 30th, 2009, 10:13 | #4 |
formerly Sepulcrum
|
Mine has what looks like 8mm brass bushings.
|
April 30th, 2009, 10:14 | #5 |
Tys
|
I dumped some bench notes in another thread...let me check. Jugglez asked me last night and I haven't replied to him yet.
***EDIT*** HERE it is... Bad news is...I think that they may even be bigger than 8mm...not sure, I didn't mic them. Good news...they're at least bronze...they'll last longer than plastic, but not as long as sintered/SS metal. ALSO...these were the G&G M4's from Mach1...I have no idea if there are lower/higher/variations of different models with different build parts... Last edited by m102404; April 30th, 2009 at 10:18.. |
|
Bookmarks |
Thread Tools | |
|
|