|
|||||||||
|
Home | Forums | Register | Gallery | FAQ | Calendar |
Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
|
Thread Tools |
January 28th, 2009, 19:37 | #1 |
G36C always 99% of the time in full auto
I cant seem to figure this one out myself.
So, its wants to fire in full-auto in semi. Yet, sometimes if i get it just right or some divine intervention it will shoot semi, in semi mode. Safety works btw. Yes, everything is lined up properly. It make be a problem or wear and tear, but I cant seem to find any wear and tear. Cut off leave? selector plate? its gotta be one of those, but again i cant notice any problems. I also do not have a spare cut off leaver to experiment with either or a selector plate...so any ideas? Its not electrical, its positively mechanical. Any ideas? Cheers, Spa |
|
January 28th, 2009, 19:49 | #2 |
dd
Last edited by gvanzeggelaar; October 8th, 2013 at 22:09.. |
|
January 28th, 2009, 20:29 | #3 |
Agreed. That would be the first place I'd look.
__________________
|
|
January 28th, 2009, 22:04 | #4 |
Tys
|
Does it do it when it's out of the lower receiver? If you're manually holding the selector plate so that it's not bumping the cut-off lever at all?
Tys |
January 28th, 2009, 22:45 | #5 |
Guest
|
check slector switch spring placement, wear on cutoff lever or sector gear.
|
January 28th, 2009, 23:33 | #6 |
ok, ill check it and get back to you chaps.
|
|
January 29th, 2009, 00:18 | #7 |
My M4 was doing that and i changed the selector plate.
|
|
February 7th, 2009, 00:08 | #8 |
My G&G M4 was doing something similar from almost new, it would fire short auto bursts in semi and a quick pull of the trigger in auto and it would continue to fire auto for 1-2 seconds AFTER the trigger was let go. I figured it was something sticky inside (cut off lever?). A short spritz of silicon spray up into the gearbox, from around the trigger, and everything worked fine afterward... go figure.
Marc. |
|
February 7th, 2009, 08:14 | #9 |
sometimes when the cut-off lever gets soaked on grease, it doesn't want to move freely anymore making the rifle in full-auto only.
__________________
5.56x45mm + m27 = M249(SAW) |
|
February 8th, 2009, 06:45 | #10 |
make sure all your springs are in place. espescally your selctor plate switch spring.
__________________
. |
|
|
Bookmarks |
Thread Tools | |
|
|