|
|||||||||
|
Home | Forums | Register | Gallery | FAQ | Calendar |
Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
|
Thread Tools |
December 23rd, 2008, 03:30 | #1 |
Systema M120 Drop in Mechbox Problem
I just bought a system drop in mechbox, m120 version. I believe that the anti-reversal latch is not working properly by not pressing against the gear due to the mechbox being tight around the part and causing it not to move.
Has anyone had this problem before and if so, what have you done to fix it. I am thinking that saving the hole a bit to make it bigger will help the anti-reversal latch move freely. FIXED - See below for solution Last edited by chrising; December 24th, 2008 at 05:54.. |
|
December 23rd, 2008, 08:37 | #2 |
Tys
|
Weird...so with just the mechbox mounted onto the grip/motor (i.e. not in the body) it fires fine? But in the body it binds?
Does the AR latch axle protrude out of the shell on either side? What body are you putting it into? |
December 23rd, 2008, 09:56 | #3 |
Check the spring, and then enlarge the hole, and if it's getting caught on the gear you might have to shim it just a little bit (or dremel away the offending area of the AR latch).
|
|
December 23rd, 2008, 21:02 | #4 |
Problem is with just the grip on, I'm going to try to enlarge the hole, see if that helps.
|
|
December 23rd, 2008, 22:04 | #5 |
Ive had problems lately with systema drop in boxes having slop in the fit of the reversal latch. I have had to shim 2 latches. If it is moving the way its supposed to without the grip on you may want to check the length of your grip screws. There could be a remote possibility they are too long and have maybe pushed against something they arent supposed to.
|
|
December 23rd, 2008, 22:24 | #6 |
What battery and motor are you using?
|
|
December 24th, 2008, 01:17 | #7 |
Captain Awesome
|
+1 lupo, i suspect the grip screws are too long.
|
December 24th, 2008, 05:53 | #8 |
FIXED
So I enlarged the anti-reversal latch hole. Seems that the hole was too small, only needed just a bit of sanding. Thanks for all of your support and ideas! |
|
|
Bookmarks |
Thread Tools | |
|
|