I think my mechbox seized?

[The Saint]

EG1000 still will crank a 400fps spring pretty well on the battery he's using. If this is a motor problem, it's a dying motor problem, not because it's not an uprated motor.

[DC_ACU]

Originally Posted by ThunderCactus

You don't have to open the mechbox to release the anti reversal latch anyway, on a V2 you just need to remove the motor and pistol grip, reach in with a hex wrench or a nail with its end bend 90 degrees and pull down on it.

thank you SO much.

finally got patient enough and sat down and tried it out today, got it firing pretty good.

but im still facing the problem of no full auto, and my STAR mags wont seat in properly, only my CA hicaps.

i loosened up my buffer tube, and it fired in full for a few minutes, but when i realized that the buffer tube was TOO loose, i had to tighten it slightly, and even the slightest tension, removes my full auto capability.

i dont really mind if my full auto doesnt work, i like counting my shots, while using locaps, but because of the mag problem, i can only use hicaps. :S

[FiveFingers]

i had this problem with my mp5 and i thought it was the mechbox but all i really needed to was get a thicker gauge wires that connect between the battery from the mechbox. and all worked well i can't remeber what gauge i used tough... hope this could help you