KWA Glock 17 Help

[CrazyGamer]

Hi, I'm having a really annoying but simple problem with my KWA Glock 17. There is a pin in the part that holds the rocket valve (I think it is called the loading nozzle or blowback chamber). The pin holds the rocket valve in place keeps on slipping out of place, there for the rocket valve does not work properly, so when the pin slips out, and I fire the gun, it vents all the gas out of my magazine. Sometimes the pin would slip out as quickly as only after 3 shots. I have taped around the pin so the pin does not slip out anymore, but the tape slows down the cycle rate of the gun a lot. Also, the two springs that help the loading nozzle spring back after fired, I bent one of the springs when I first tried to take the blowback chamber apart (when I didn’t really know what I was doing). I don’t really know if the springs have an effect on the problem. I was wondering if anyone knows how to completely fix this problem. Thanks.

[Styrak]

What part is it?

[Tex]

if it is part 26 your talking about just glue it in place.

[CrazyGamer]

Yeah, it is part 26. Super glue will work fine right? I have a metal rocket valve, but if it breaks and the pin is glued should I just by a new part off of airsoft parts?

[Tex]

Super glue should be fine. If you are worried about removing it later then try only glue one side, a good tap from a pin extractor should pop it out. I've had three kcs glocks for years and really only needed that pin out once each so you should be good for awhile anyways.

[CrazyGamer]

Okay, thanks.