|
|||||||||
|
Home | Forums | Register | Gallery | FAQ | Calendar |
Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
|
Thread Tools |
February 1st, 2006, 19:48 | #1 |
G36C Trigger return problem
I just finished putting gears, spring etc.. in my TM G36C mechbox. everything went together fine and the shimming seems good but in semi auto mode the trigger will not spring back for a full cycle it will prepare to fire another round if I press it forward. on full auto it seems to be just fine.
Any Ideas? Thx |
|
February 2nd, 2006, 16:28 | #2 |
Fixed!
The trigger spring was not sitting inside the small hole on the left half of the mechbox. It's always the little things. Thanks anyhow! |
|
|
Bookmarks |
Thread Tools | |
|
|