|
|
|
|
|
||||||||
|
|
|||||||||
| Home | Forums | Register | Gallery | FAQ | Calendar |
| Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
 |
|
|
Thread Tools |
May 4th, 2016, 16:00
|
#1 |
|
LCT AS VAL Motor Height Issue
Hello all!
recently got my hands on a LCT AS VAL and ive ran into a small problem when starting to shim it and hopefully someone might have ran into the same issue. It seems I cant get the Motor Height high enough to make proper engagement, Ive screwed in the adjustment screw as far as it goes and its still I'd say 1-2mm off. Is this a normal thing due to the different angle of the motor cage? Any fixes? |
|
|
|
May 4th, 2016, 16:20
|
#2 |
|
Never worked on one so I might be way off, but can the screw be replaced with longer?
Or is as simple as the motor pinion sitting too far down the shaft?
__________________
Looking to get age verified in York region? Click link... |
|
|
|
|
May 4th, 2016, 19:28
|
#3 |
|
|
New screw won't do it any good because the motor shell is hitting the top of the motor cage. Seems like the pinion needs to be seated up higher but it's already at the "normal" height
|
|
|
|
|
May 4th, 2016, 21:03
|
#4 |
|
Not Eye Safe, Pretty Boy Maximus on the field take his picture!
|
The bevel needs to be shimmed closer to the pinion gear
|
|
|
|
|
May 5th, 2016, 00:13
|
#5 |
|
"bb bukakke" KING!
|
did you buy it new? if you did, take it back.
If you bought it used or someone upgraded it, the shimming of the bevel is off.. it's probably so low that the pinion will not reach it. If no warranty can be claimed, then it will need to be opened up and reshimmed.
__________________
I futz with V2s, V3s and V6s. I could be wrong... but probably, most likely not, as far as I know. |
|
|
|
 |
|
||||||
| Bookmarks |
| Thread Tools | |
|
|
 |
|
