|
|||||||||
|
Home | Forums | Register | Gallery | FAQ | Calendar |
Retailers | Community | News/Info | International Retailers | IRC | Today's Posts |
|
Thread Tools |
October 27th, 2015, 01:52 | #1 |
[Solved]Trigger lockup by switching from full auto to semi
I finally had time to take the gearbox apart from this KA m4 that I bought from someone who said it has semi problem and his brother opened it..Okay, not a big deal..(original problem was that it skips one trigger pull, so no shoot, shoot, no shoot, shoot) I can hear that the gears seems to be over spinning or something..
After I open the gearbox, I immediately noticed the the anti-reversal latch's spring is installed backwards. Also the spring seems shorter than normal (usually the spring arm on the object itself wraps to the top of the anti-reversal latch, this one doesn't) After I did that, I also checked trigger contacts, cut off lever and general wear & tear on the internals..surprisingly, nothing seems worn..So I was like great, put it back together. now semi shoots fine now..HOWEVER, every time I switch to full auto, shoot a few rounds and then go back to semi, semi would lockup. To clear the lock up, I need to switch to full auto again, shoot a few rounds, and then semi would start to work. The semi shot after the clear seems to be weaker tho... Im not sure what's wrong at this point..
__________________
Last edited by Slodin; October 29th, 2015 at 23:43.. |
|
October 27th, 2015, 02:18 | #2 |
Squid Porn Superstar, I love the tentacles!
|
Take a video, it cold be that your anti reversal latch is still not catching consistently.
|
October 27th, 2015, 11:46 | #3 |
Prancercise Guru
|
__________________
Airsoft, where nothing is hurt but feelings. |
October 27th, 2015, 14:07 | #4 | ||
Quote:
Quote:
if I only use semi there is no problem at all, it fires fine. EDIT: WEIRD...got home and tested it again, now it's fine...I will keep on trying to see if it happens again...
__________________
Last edited by Slodin; October 27th, 2015 at 18:14.. |
|||
October 29th, 2015, 19:31 | #5 | |
Quote:
|
||
October 29th, 2015, 23:46 | #6 | |
Quote:
Couldn't get it to do this anymore which is good.. maybe it's because the day I tested was because the deans was freshly soldered on? the next day it's flawless... too bad I can't fit a bigger battery in my peq box...only a 7.4v 1500mah 20c lipo..
__________________
|
||
October 30th, 2015, 01:28 | #7 |
Not Eye Safe, Pretty Boy Maximus on the field take his picture!
|
Most likely the voltage on the battery dropped slightly because you were using it. Dropped just low enough that your gun stopped cycling into the wrong spot.
Try charging the battery again and see if it happens again. As far as I know, the connection between a wire and a deans connector doesn't "age" and increase resistance. 110% certain it doesn't do that over the course of 24 hours lol |
|
Bookmarks |
Thread Tools | |
|
|