Bolt action help

[VooDooPeteK]

Ok so maybe some of the bold action guru's can help on this one.

One of my bolt action guns was shooting just fine but was stock so I decided to strip it down and clean the fish oil grease and re lube it.

I have added no upgrades just stripped it, cleaned the barrel, re lubed the piston and cylinder, gave the piston head o ring a silicon oil bath along with the cylinder head o ring. Oh and I added some Teflon tape around the cylinder head threads.

now it seems to be double feeding with every shot


Any help would be great

Thanks

[Specs]

Originally Posted by VooDooPeteK

Ok so maybe some of the bold action guru's can help on this one.

One of my bolt action guns was shooting just fine but was stock so I decided to strip it down and clean the fish oil grease and re lube it.

I have added no upgrades just stripped it, cleaned the barrel, re lubed the piston and cylinder, gave the piston head o ring a silicon oil bath along with the cylinder head o ring. Oh and I added some Teflon tape around the cylinder head threads.

now it seems to be double feeding with every shot


Any help would be great

Thanks

what type is it?

[ozzy5]

did you check hop up and see if nub is still there

[VooDooPeteK]

yea its still there, the more rounds I put through it the better it seems to get so i think its just the new lube job

[Kos-Mos]

If it's an L96 type and you put too much oil in the cylinder, the extra oil will get shot into the barrel and hop-up rubber, that is the reason why i will double feed.

If you have a VSR-10 type, they you might have an other problem as there is a latch that only lets one BB in at the time.

[VooDooPeteK]

Originally Posted by Kos-Mos

If it's an L96 type and you put too much oil in the cylinder, the extra oil will get shot into the barrel and hop-up rubber, that is the reason why i will double feed.

If you have a VSR-10 type, they you might have an other problem as there is a latch that only lets one BB in at the time.

well is an ASR so l96/aps2 type

yea I think there was a bit to much lube added by me as the more rounds I push out the better its getting

thanks for confirming it though

[Kos-Mos]

Remove your barrel and clean your inner/hop-up unit again.

If I remember it uses a L96 type hop-up and inner barrel.

[VooDooPeteK]

yea I am gonna strip it and clean it all out

seems to be just the last few bb's in the mag that are double feeding, same in all 3 mags