Very strange G36 pistol grip electrical glitch

[theguy]

SOLVED!!! !

Turned out that the amount of pressure to activate the swich on my new KA wiring harness was more then on the old stock JG harness.

Solution? File back a bit of the back end of the trigger hole on the lower reciver until you can get it to connect.

Now.... if only i could solve my wierd airseal issue... but thats a whole other can of worms :P

[Kos-Mos]

About your airseal issue...

Check the piston/cylinder/nozzle assembly for leaks, if there is none, your problem is the same as in my old JG.


Shave about 1/2 mm from the REAR face of the little nubs on your hop-up unit.

The two little tabs that keep the hop-up unit from springing out when you remove the mechbox.

Mine had some burs/moldings that prevented it from sitting far enough back...

[theguy]

Ill check that.

Actually, the hop-up isn't stock, Its a Pro-win CNC hop-up chamber, with a Gaurder clear rubber. Also, the front barrel assembly that the hop-up slides into has already been replaced with a TM barrel assembly

[SHÖCK]

Originally Posted by theguy

SOLVED!!! !

Turned out that the amount of pressure to activate the swich on my new KA wiring harness was more then on the old stock JG harness.

Solution? File back a bit of the back end of the trigger hole on the lower reciver until you can get it to connect.

Now.... if only i could solve my wierd airseal issue... but thats a whole other can of worms :P

Haha, that's what I said in http://www.airsoftcanada.com/showpos...4&postcount=17 :P Grind away at the plastic behind the trigger.

If you have done a compression test on your cylinder and there is no airleak there, the airseal problem is caused by the plastic faux bolt assembly and/or the pro-win combination.

I had the plastic assembly that came with the JG but it was shooting 350 FPS. I took it out and with everything exactly the same, I popped the stock hop-up and barrel all together into a metal CA one. Instantly, the gun was shooting 411 FPS. The metal one holds the hop-up unit MUCH further back and therefore when the mechbox nozzle hits it, it makes very tight contact and no air leaks out between the nozzle and hop-up. In fact, it was so far back, I had to sand a channel into the magwell feed lip to get BBs to feed a bit further back...And to test my theory, I swapped back in the old plastic assembly again and voila, back to 350 FPS. Metal one in and 411 FPS.

[theguy]

how did i miss that >.>

Oh well, thanks a lot SNK, and ill take a look at the hop-up tonight