|
It would be pretty easy for me to modify the end of my sniper stock to accept the back piece from my normal M16 stock. The only issue I would have is that the screw that holds the stock in place might be too long. When I get off work I I'll see how deep I can screw the screw into the upper reciever. I would need to screw it in about an inch deeper than I normally would. If that doesn't work I would need to find a shorter screw and I have no clue about going about that one.
On a side note, how much of the gun do I need to disassemble to remove the trigger grip?
I really want to put this stock on....it looks so good when I line it up so it looks like it is attached.
__________________
|