Airsoft Canada - View Single Post - G19 Weak/no Shots after Hammer Assembly was Disasembled.

Nick_273 · November 3rd, 2008, 19:57

So several days ago i received my Shooters Design steel impact hammer. After filling down the edges, as has been suggested to me, it fit into its place perfectly. I reassembled the hammer assembly which took about 20 minutes after using some tape to hold that dam impact hammer in a horizontal position (those of you who have done this before know what im talking about). I try pulling the trigger several times with the slide off, and recooking it with my thumb and everything seems to be working just as it did before.

When i put the slide back on, lubed everything up, and put the mag back on i was feeling pretty confident that this was a successful upgrade. I pull the trigger and SPEEEWWWWWWWW... all the gas in the mag spews out. I try again, and this time it shoots several EXTREMELY weak shots which are unable to push the slide back far enough to complete its cycle and re-chamber a bb.

So i take my gun apart again and i notice that the hammer spring seems to be sitting a little lose, everything else seems to be in place. I have taken apart the entire assembly several times to look for anything that i might have done wrong during the re-assmebly procces, but everything seems like it SHOULD be working...

I made a video and uploaded it to youtube so if you guys want to take a look, here it is.

http://www.youtube.com/watch?v=uxR0EYJ5K8U

I'm out of ideas, so any useful advice would be appreciated
If anything is unclear, just ask.

November 3rd, 2008, 19:57	#1
Nick_273 Trader rating Join Date: Jan 2006 Location: Vancouver Island, BC	G19 Weak/no Shots after Hammer Assembly was Disasembled. So several days ago i received my Shooters Design steel impact hammer. After filling down the edges, as has been suggested to me, it fit into its place perfectly. I reassembled the hammer assembly which took about 20 minutes after using some tape to hold that dam impact hammer in a horizontal position (those of you who have done this before know what im talking about). I try pulling the trigger several times with the slide off, and recooking it with my thumb and everything seems to be working just as it did before. When i put the slide back on, lubed everything up, and put the mag back on i was feeling pretty confident that this was a successful upgrade. I pull the trigger and SPEEEWWWWWWWW... all the gas in the mag spews out. I try again, and this time it shoots several EXTREMELY weak shots which are unable to push the slide back far enough to complete its cycle and re-chamber a bb. So i take my gun apart again and i notice that the hammer spring seems to be sitting a little lose, everything else seems to be in place. I have taken apart the entire assembly several times to look for anything that i might have done wrong during the re-assmebly procces, but everything seems like it SHOULD be working... I made a video and uploaded it to youtube so if you guys want to take a look, here it is. http://www.youtube.com/watch?v=uxR0EYJ5K8U I'm out of ideas, so any useful advice would be appreciated If anything is unclear, just ask.