|
You're taking a CQB gun and making a DMR... Sounds pretty typical these days.
Change your question to how you can make your gun as accurate and combat effective as possible.
Prometheus 6.03 inner barrel
Flat-hop (Suggestions please!) R Hop
Some sort of aftermarket SIG air nozzle (Correct me if I'm wrong, not really sure what type of nozzle actually fits) SiG nozzle is correct, however the CA hop up chamber has a very small internal diametre. I'm not sure why. Lonex nozzle does not fit, but my Modify nozzle did after I widened the hop up unit a bit. Easiest to use the stock nozzle as it already has an internal O-Ring.
M130/M140 to get a fps between 420-450 If your air seal is any good a M130 will get you 480 FPS and M140 will get you 500+. A M120 will put you around 440-450 as long as your air seal is good.
Upgraded Cylinder/Cylinder head (Suggestions please!) Any metal cylinder head will do as long as the nozzle does not wobble on it too much. Avoid teflon coated cylinders like Modify and Lonex, only use steel cylinders like SHS and ZCI.
Upgraded Piston/Piston Head (Suggestions please!) Lonex Piston or SHS Piston, Lonex POM Piston Head.
Low ratio Gearset (13:1)
SHS High Torque Motor
Silver Wiring (Stock wire breaks easily) Read below.
Some sort of Mosfet (Suggestions please!) 3034 MOSFET or BTC Unit. Both will come with wiring. Avoid Gate units.
11.1v Lipo Battery
|