[phloudernow]

Thanks E!!! ill check that out!!!

Oh btw your inbox is full couldn't reply you about that PM

Originally Posted by e-luder

Phil,

THE two bolded components are a red flag for me.
I would swap out some internal stock components to see which one is causing what.

I know for a fact that the GunsModify BBU can act a bit wonky with aftermarket parts. Specifically piston heads. lol.

But yeah. I think that bearing and BBU combo might not be acting correctly.
So just swap a stock BBU to test the functionality of your Action 8mm bearing. Then swap to the stock bearing, to check and see if the Gomodify BBU is acting correctly. That's what I would do....

OR

THere's isn't not enough blowback to lock you hammer to sear hooks. That means that your gun is essentially short stroking.

Improve your piston head seal. Increase the hammer spring tension. And if neccessary, downgrade your recoil spring tension...

This increases your gun's capacity for blowback operation. Good seals + less resistance during the rearward stroke gets you a charged hammer (theoratically)...

There might be something else at play that I'm overlooking but I would start there....