Quote:
Originally Posted by redneck12
All you need to do is mark where the barrel meets the bushing and then use a pipe cutter to do a rough cut a few millimetres away from your desired cut then file the remainder flush and smooth with sand paper and emery paper. I use this method on all my 1911's, or if your unsure of your modding abilities you could order an after market barrel.
|
I think his model has a black barrel, so after cutting and polishing it would also need a bit of black paint.
It's still what I'd do.
Or course, my KJW has a silver barrel so no paint was required.
I also cut the barrel right at the edge of the orange paint. The amount that sticks out seems to be in keeping with photos of real M1911 pistols.
