Quote:
Originally Posted by ArcticFox1984
I experienced this with a TM G18C.
The original nozzle blew out in under 100 rounds after I installed some common upgrade parts including a pgc slide; followed by 2 guarder nozzles in less then 20 shots combined...
In the end what I had decided was that part 18C-15 was causing the problem by tripping up 18C-14 not allowing that spring to cycle.
1.) cut 18C-15 down by a small amount ( about 1/3-1/2 of the thinner side that meets the slide. )
2.) gently and carefully stretch 18C-14 by a similar amount to make up for the lost tension.
3.) on the side of 18C-15 that joins up with 18C-14 sand it down from a cylinder to a cylinder with a hemisphere on top.
4.) lightly grease G18C-14 and 15.
Since then I've put 400-500 rounds through it without issue.
|
can you post a picture or explain it better....i just don't get it lol