Airsoft Canada - View Single Post

Noob7_0 · August 10th, 2012, 19:51

After knowingly pushing my M4 at Rhino I stripped my bevel gear. Currently I am using 7.4v 1100Mah 15C Lipos (with a simple MOSFET) with a Guarder Infinite Torque up motor and a spring giving me 380-400fps. I purchased the gun used, it had a selector plate mod to fire semi only. I have since rebuilt it to fire in auto and pushed it too hard. What type of gear set should I install?

My goal is to not to achieve a high rate of fire I would just like the gun to fire in FA and not tare itself to death.

At my disposal I have a CA high torque motor. The shaft (sorry don’t know the official name) of the CA motor is shorter than the Guarder motor so I am a little hesitant to swap them out as I don’t know if the CA fits properly. Unfortunately I don’t know what type of piston I am running but it does have metal teeth and a silent piston head. I also have a sorbo pad that I have yet to install.

Through some skimming I think I need a set of torque up gears to match my motor. Also, from my reading I see that this gear set and motor are better for slow rate of fire guns. Should that combo be restricted to semi only/marksman type setups? Am I ok running them on a MK18 or should I change my motor as well?

What is my best course of action?

August 10th, 2012, 19:51	#1
Noob7_0 Trader rating Join Date: Jun 2011 Location: Cambridge, ON	Need a New Gear Set After knowingly pushing my M4 at Rhino I stripped my bevel gear. Currently I am using 7.4v 1100Mah 15C Lipos (with a simple MOSFET) with a Guarder Infinite Torque up motor and a spring giving me 380-400fps. I purchased the gun used, it had a selector plate mod to fire semi only. I have since rebuilt it to fire in auto and pushed it too hard. What type of gear set should I install? My goal is to not to achieve a high rate of fire I would just like the gun to fire in FA and not tare itself to death. At my disposal I have a CA high torque motor. The shaft (sorry don’t know the official name) of the CA motor is shorter than the Guarder motor so I am a little hesitant to swap them out as I don’t know if the CA fits properly. Unfortunately I don’t know what type of piston I am running but it does have metal teeth and a silent piston head. I also have a sorbo pad that I have yet to install. Through some skimming I think I need a set of torque up gears to match my motor. Also, from my reading I see that this gear set and motor are better for slow rate of fire guns. Should that combo be restricted to semi only/marksman type setups? Am I ok running them on a MK18 or should I change my motor as well? What is my best course of action?