Airsoft Canada - View Single Post

Luujerr · January 14th, 2012, 11:41

hey guys, just wanted to let you guys know how I fixed my kc-02.

- because the outer barrel is bolted into place on the receiver only on the lower side of the barrel, if you torque in the two bolts too much it forces/pulls the outer barrel down. To fix this i just put a couple layers of electrical tape under the outer barrel to wedge it up.

Here's a photo to give a rough idea of what I did... (this was too much tape)

this along with a clean hop-up fixed my issue perfectly. I came up with this after i noticed that the back of the receiver seemed to droop down in relation to the front of the barrel.

This gun is crazy accurate! power went up considerably with a 510mm tbb. It has little too much power now. I will be installing the steel bolt and maybe getting a shorter tbb.

January 14th, 2012, 11:41	#199
Luujerr Trader rating Join Date: Jul 2009 Location: Markham, On	hey guys, just wanted to let you guys know how I fixed my kc-02. - because the outer barrel is bolted into place on the receiver only on the lower side of the barrel, if you torque in the two bolts too much it forces/pulls the outer barrel down. To fix this i just put a couple layers of electrical tape under the outer barrel to wedge it up. Here's a photo to give a rough idea of what I did... (this was too much tape) this along with a clean hop-up fixed my issue perfectly. I came up with this after i noticed that the back of the receiver seemed to droop down in relation to the front of the barrel. This gun is crazy accurate! power went up considerably with a 510mm tbb. It has little too much power now. I will be installing the steel bolt and maybe getting a shorter tbb. Last edited by Luujerr; January 14th, 2012 at 12:29..