M4 G&P metal body upgrade
 

anyone know where theres a walk thought for this iv been working on it for 6 hours now.. and i can get it right.. help me out plz
--------------------------------------------------------------------------------------------------------------------------

Well i finally got the time to finish getting it back together, just wanted to thank everyone that helped!!
here a pic tell me what you guys think, its plain nothing special but i like it!!

http://i177.photobucket.com/albums/w...9/IMG_1128.jpg

here is more of my collection!

http://i177.photobucket.com/albums/w...9/IMG_1129.jpg

Let us know what you are having problems with and we shall be able to help you.

Yeah, what's the problem? I installed 2 kits and it was straightforward. Be glad to help.

1. barrel lock nut wont fit.. original seen to small for G&P receiver!
2. how do you get the bb feed guide to stay in place.
3. do you have to slide the mech box in to the top of the receiver and then put the bottom on.. if so how do you get the mech box out with out twisting the inside dust cover (piece that pulls back to reveal hop up)

NVM about the bb feed guide.... got that one figured!

In both my installs, I was using CA's front end kit and the barrel lock nut was fine. Original gun was a TM and an A&K.

1: If its to small, you will need a different one, or something isn't ligned up

2: Yes, slide in the upper, then reatache the lower then reassemble. You can do it the other way but this way I find it is much easier and you minimize the chance of breaking a body tab.

3: Hop up attaches to the barrel with a C Clip.

The mechbox needs to be installed into the bottom half of the receiver. You fit the top part by sliding it in atth efront of the mechbox.

G&P mb kits do not have any body tabs.

i know they dont.. but do you put the mech box in to the upper receiver first??

You can do it either way, lower first or upper first, no body tabs to worry about, as stated.

I stand corrected, but you can still do it either way.

No, I fix it to the lower receiver first by installing the small mechbox pin and rear locking pin. Then only do I attach the long buffer tube screw and pistol grip screws and all other items.

On my second build with the A&K base gun, the original pistol grip was not the same angle as the TM causing the mechbox to tilt slightly as I was tightening the pistol grip screws. I could not insert the small body pin and rear locking pin.

It's easier for me doing it this way as the mechbox is permanently fixed into position inside the lower receiver.

so where can i find a delta ring that will fit!

What's the make of your original gun?