Frontal Wire M4 QD connectors
 

ugh...why KA don't make it easy..

I ordered some 22AWG spade connectors to act as a disconnect between the front barrel and the upper receiver so I can do maintenance on my AEG easier..so far I have been soldering the deans on and off...

however I noticed these 22AWG are actually 16-22AWG upon arrival..well shit they are far to large to fit in that small hole...so now im trying to track down 22-26AWG spade connectors which I can't find anywhere...not in home depot, rona, rc stores (they won't sell them but offer to do the job for far too much), ebay, aliexpress, amazon...

anyone know where to get some of these? both male and female ofc...:banghead:

Thanks

digikey maybe?

How about some 2mm banana/bullet connectors?

http://www.dx.com/p/2-0mm-bullet-ban...4#.Vr6KwkU8KJJ

I have some 0.110" male & female connectors (motor terminal sized) I could mail you if you only need a few only.

lol their min order quantity is beyond my use LOL...5000pcs...

those motor terminal sized ones might just be the ones I need...I only need 2 sets..I can e transfer the money to you for shipping and the connectors..I don't imagine the shipping would be much..

I heard the bullet ones are harder to open..and i'm not sure for 2mm going through that channel...

great hobbies would have 2mm bullet connectors.

Slodin: Pm sent

I'm so glad I came across this thread. Same position as OP with my KA.. need to find some quick disconnects. I'd be willin g to buy them off you.